Heating /Lighting and ventilation ideas

Status
Not open for further replies.

yarok

Member
5 Year Member
Joined
Feb 29, 2012
Messages
223
Just finished waterproofing my new plywood enclosure, using Thomsons water sealant (hope this stuff works). I am thinking about installing some plastic or some kind of extra coating on the bottom few inches where the substrate will sit. It is 48 x 24 x 24. I will be installing the plexiglass doors as soon as the track comes in the mail (I found it online for 8 bucks). I do however need ideas for ventilation and heating/lighting. Advice would be much appreciated. Thanks guys.
 

slowpoke

New Member
5 Year Member
Joined
Nov 17, 2011
Messages
360
Location (City and/or State)
colorado springs, colorado
for ventilation i use a computer fan i wired up to a 6.7v plug i cut a small hole in the side of my enclosure works great , for heat and light i would go with a MVB , they cost a bit but they are every thing on one , heat and light ...
 
Status
Not open for further replies.

New Posts

Top